Sr Post Name Jobs Qualification
1 PCB Design Engineer 1 Masters
2 Senior Engineer 1 Masters
3 Lead Engineer 1 Masters
Latest jobs by Bahria Enterprise Systems & Technologies
Designation Qualification Job Description/Skill Set
Lead Engineer RE & Microwave Specialist 3 - 5 Years BE in Electrical/ Electronics/ Industrial from HEC recognized University Be able to:
  • Repair/ diagnose FPGAs especially ALTERA/ XILINX FPGAs Undertake programming of FPGAs through VERILOG/ VHDL
  • Program 32-bit ARM based Microcontrollers using C / Assembly language
  • Read/ Write and Extract FPGA/ Microcontroller programs through JTAGs/ Ethernet/Serial Port
  • Perform on-chip Debugging of FPGAs/Microcontrollers
Lead Engineer RF & Microwave Specialist 3 - 5 Years
  • Use RE/ Microwave Test Equipment (e.g Spectrum Analyzer, Network Analyzer, Power Meter, RF Source Generators etc) for repair/diagnosis of RE/ Microwave circuitries
  • Test and repair following types of RF Components: -Active (LNAs, Pre Amp, Power Amp, Mixers etc) -Passive (Filters, circulators, isolators etc)
  • Electromechanical (Crystals, Resonators, Oscillators etc)
  • Program/ tune Combined RF and Mixed Signal based circuitries comprising of AGCs, DSPs etc
Lead Engineer PLC Programmer
2-3 Years
  • Read/ write and extract PLC programs through serial port/ interfaces.
  • Program/ diagnose PLC using Ladder Logic
  • Repair/ diagnose defective PlCs for operationalization
  • Undertake interfacing through communication/ connectivity protocols i.e. Ethernet, UART, CAN, SPI, I2C
Sr. Engineer PCB Design Specialist
2-3 Years
BE in Electrical/ Electronics/ Industrial from HEC recognized University
  • Perform complex PCB designing on any PCB Design Software i.e. Proteous, PADs, Altium and Mentor Graphics DX Designer
  • Recognize electronic components, ICs packaging, datasheet reading, components functional testing and analysis with testing equipments
  • Develop PCB Schematic, layouts, perform components placement and determine wire routings of multilayer PCBs
  • Perform functional replacement designing of PCBs
  • Verify existing designs and recommend improvements.
PCB Design Engineer 2-3 Years
  • Perform PCB designing on any PCB Design Software i.e. Proteous, PADs, Altium and Mentor Graphics DX Designer
  • Recognize electronic components, ICs packaging, datasheet reading, PCBs layouts and layers etc
  • Carry out PCB components testing and analyze design parameters.
  • Check and validate PCB design.
 

For details & online application, visit www.best-bf.com/careers or post detailed CV along with supporting documents, copy of CHIC and a recent photograph to jobs(Obest-bf.com or mail to "Bahria Enterprise Systems & Technologies 2nd Floor, Bahria Complex II, MT Khan Road, Karachi" by 31 Oct 21.

For inquiry: 021-35644507 & 35610813,
(ONLY SHORT LISTED CANDIDATES WILL BE CONTACTED)